LCD Smartie

I use speedfan on all PCs, however on some of them I notice that at lower speeds, speedfan registers 0 RPM for fans that ARE infact moving.

Is there anyway to get the SPEED SETTING (percentage full speed) from Speedfan?

ie.
CPU 1300RPM 50%
I have a few botched fans that don't have the third speed controller cable, but I've attached to the systemboard so speedfan can control the speed, but I can't see a way to get this speed in lcdsmartie.

No way, just fan speeds, temps and volts are available.

on new fans the 3rd (yellow) connector cable tells the computer the rpm. so if you only have a two pin or molex connector fan there is only +12 volt and ground no speed checker