can you change the number of lines Smartie will support

Miehas · Post by **Miehas** » December 5th, 2005, 1:26 am

I have a 64 X 128 LCD I am thinking about hooking up. But I have noticed that Smartie's Drop down only goes up to 4 X 20.

Is there a way of increasing this in Smartie?

_X7JAY7X_ · Post by **_X7JAY7X_** » December 5th, 2005, 6:29 am

64 X 128........now thats big

Where did you get that from?

J

Post by **limbo** » December 5th, 2005, 3:46 pm

I believe that your LCD is not character type...

This dimension is for graphical types... and officialy are not supported by the program.

Can you provide some more information about your LCD model?

penjuin · Post by **penjuin** » December 6th, 2005, 8:24 am

Yes, I believe you do have a graphic LCD. I play around with them a bit. You actually have an 8x20 display if used for characters. Have a look at the ICs on the back; see if one says T6963C, KS108, HD61202 or SED133*. If you see one of these I can help you out. Also, you are almost definitely going to have to build a voltage inverter.